1. Unhook the elevator spring located on the front side of the unit. (Be sure to first unhook the spring from the lifter side as shown in the upper part of the diagram.) 2. Lift the lifter unit upward, then remove the lower rod to remove the lifter unit from the chassis.
Unhook this part first
Lifter Bracket
1. Remove the two lifter bracket fixing screws (4) located on the back of the lifter unit. 2. Remove the lower rod.
Fig. 21
Proper orientation
Side Bracket and Traverse Mechanism
1. Remove the two side bracket unit fixing screws (5) to disconnect the side bracket unit from the lifter unit. 2. Remove the three shafts on the traverse mechanism assembly from the lifter unit.
Lift up the lifter unit
For reassembling, refer to the reassembling procedures.
